![]() ![]() Thanks rschoi_75's set-up guide, most of parts are the same, only RX part are different. you can check you control command here. Motor Jitter/Start up spinning -> Type: "set motor_pwm_rate=16000" enter. I usually put the Angle mode on AUX2, Horizon on AUX3, Acro/Rate mode if both off. Acro/Rate mode is the default, so if you wish to use Angle and Horizon, you will need to set it now. Set "ARM" to AUX1 if you wish to arm via AUX1 button. Min Throttle = 1000, Max Throttle = 2000, Min Command = 1100 You may need to flash older version or build a 'RX_MSP' enable version firmware.ฤก) connect FC using Clean/Betaflight configurator via USB cable (depend on what firmware FC used) also you need to install aorus engine and hit the image reset button most of the time that bring the screen back to life edit important do not update to aorus engine version 1.9.6 or 1.9.7 there is a bug with the aio cooler stay on version 1.9.5 that version is working with the cooler without any problem let's just hope that version 1.9.8 has. ![]() Note: remove 'RX_MSP' for all F3 board, which is needed for control from app. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |